Send us a message, We will reply in 24 hour!

acting hydraulic jack 500kn anchor bolt pull out force teste

ML Series Anchor Bolt Pull Out Tester Operational Video - YouTube

Edge Testing Pull-out Anchors - Good Use Hardware Co , Ltd, chemical anchors manufacturer in Taiwan - Duration: 2:07. Taiwan Good Use Hardware 4,870 views

Online Chat Send Inquiry
Anchor Pullout Test, SPIT EPCON C8, ENERPAC - YouTube

Anchor Pullout Test, SPIT EPCON C8, ENERPAC Kamran Chowdhery ... ML Series Anchor Bolt Pull Out Tester Operational ... Enerpac 100 Ton H Press Frame w/ RR-10013T Double Acting Cylinder 13 ...

Online Chat Send Inquiry
500KN Concrete Pull Out Test Apparatus - alibaba.com

Anchor Bolt Pull Out Force Tester is used for determining the bond strength between anchored. reinforcing steel bar (rebar) and concrete and for checking anchorage performance in-situ. Manual Dial gauge is connected to a 50 tons capacity hydraulic jack and hand pump provides 1 % sensitive load or tensional strength value readings.

Online Chat Send Inquiry
Anchor bolt pull out tester - servereal.com

The anchor bolt pull out tester is mainly used to test the anchorage force of different kinds of anchorage devices, it's kind of a very common construction engineering testing equipment.

Online Chat Send Inquiry
20 Ton Chemical Rock Anchor Pullout Test - Mick Peterson

the jack to the rod was to be pretension with a torque wrench set to 100 ft-lb which is equivalent to ca. 1200 lb of tension. The described test setup would allow the group to theoretically apply an upward force in the range of 0-40000 lb which well exceeds the calculated loads on a single anchor bolt in the preceding section.

Online Chat Send Inquiry
Pull Out Force Tester, Pull Out Force Tester Suppliers and

.com offers 137 pull out force tester products. About 32% of these are testing equipment. A wide variety of pull out force tester options are available to you, such as universal testing machine, tensile testing machine.

Online Chat Send Inquiry
Concrete Bond Strength, Pull-off and Anchor Pull-out Testers

The anchor tester then applies a load with the use of a mechanical screw arrangement acting through a hydraulic load cell, which measures the load directly applied to the anchor. Humboldt provides an extensive selection of Anchor Pull-Out testers with pulling capabilities from 5kN to 145kN.

Online Chat Send Inquiry
On S Testing: Pull out test Sicherheitstraining: Funkenflug

The report is specific to the test carried out Description Item Number Anchor Pull out test Contents On-site testing ≤ 30 kN Hours 2116908 Test Evaluation report: Hilti provide test evaluation report after the pull out test is done. This test evaluation is done by our extremely trained and competent Engineers. Test evaluation report helps in 1)

Online Chat Send Inquiry
Hilti HAT 28M (Master) Anchor Tester Kit | Hire | Inlec

The Hilti HAT 28M (Master) Anchor Tester Kit is used for testing pull-out loads of anchors, ringbolts, insulation anchors, DX pins and studs, and screws in test labs and on site. Hire a Bolt Testing Kit from Inlec UK for Next Day Delivery.

Online Chat Send Inquiry
Pull testers - Force and torque testing solutions: Com-Ten

We have different range and package of pull testers dedicated to each application: analog, digital, screws, bolts, insulation adhesives, anchors... From an analog pull tester to a digital force gauge, Andilog has the force testing equipment you require.

Online Chat Send Inquiry

Video

Video

Main Pages

Our Factory

Founded in 2012, Gaode Equipment Co., Ltd. (short:“Gaodetec”) owns the most advanced imported production equipment and complete production technology...